Build Plate Installation

1 Install Build Plate

The AON-M2 comes with a removable build plate, secured with a removable tab in front of the bed assembly.

With a 3 mm hex screwdriver, unscrew the two(2) M4 screws that hold the front tab. Remove the tab.

Install the build plate by sliding it under the angled tabs, located on the sides of the bed assembly, until it hits the rear stopper block. It is sometimes easier to wiggle the build plate when sliding the build plate.

Build Plate Installation

Replace the build plate locking tab, and tighten the two (2) M4 screws with a 3 mm hex screwdriver.

Build Plate Installed
Warning

When removing the build plate after a print job, the following parts will be very hot: the locking tab, the build plate, and the bed assembly. Make sure to wear heat resistant gloves when removing or installing the build plate.

Did you find it helpful? Yes No

Send feedback
Sorry we couldn't be helpful. Help us improve this article with your feedback.