1 Carbon Fiber Polyether Ether Ketone (CF PEEK)
CF PEEK is classified as an experimental material for advanced users.
While you are free to use any brand and type of material you wish on your AON3D machine, we can only provide support for AON3D-approved materials that we have tested and developed processes for in-house, all of which can be purchased from AON3D directly by contacting email@example.com.
1.1 General Process Settings
1.2 Usage Notes
220.127.116.11 Build Surface Preparation
CF PEEK prints best on the AON-M2 High-Temperature Build Plate with the use of a brim or raft. Note that PEI surface of the High-Temperature Build Plate should be periodically resurfaced using a mill, or with an orbital palm sander if no milling services are available.
Please contact firstname.lastname@example.org if you currently have an AON-M2 Aluminum Build Plate and would like to upgrade to the AON-M2 High-Temperature Build Plate.
18.104.22.168 Material Pre-treatment
CF PEEK is extremely susceptible to moisture uptake. We recommend drying the filament overnight at 100ºC before use, and to always store in a sealed container with dessicant.
Take care to check the spool material of your filament prior to baking your material. Some vendors use low temperature materials for spools which may melt or deform at bakeout temperature.
Please contact email@example.com for any questions on this matter.
22.214.171.124 Support Material
There is currently no compatible support material for CF PEEK - prints will require self-support.
1.3 Sample Slicer Profiles
Assumes 0.6mm nozzle installed.